This is a solenoid driven gate lock meant for absorbing impacts and pressure on the gate so that the pressure is not exerted on the gate opener motors. Because the gate lock comes with a wire that leads back to the control board of the gate opener, it can release the gate lock at the same time that it runs the motors of the gate opener, leaving the system a fully automated system. The gate lock has a manual key release in instances of power loss to manually open the gate.
This device is especially handy in areas with high winds or remote areas where people may mistake a driveway for a continuation of the road and try to push the gate open. There are two components to the lock; a mechanized side and a receiving bracket. The mechanized side always goes on the gate for a single gate and on the primary gate for a dual gate. This way the wire can be run down the frame of the gate and across the joint where the hinges are to the control board for activation. The receiving bracket either goes on an adjacent post for a single gate or on the secondary gate leaf for dual gates. For single gates, the rear face of the gate must match flush with the rear face of the adjacent post - if it does not, use the column mount lock receiver.
Frequently Asked Questions
1. Is this product an easy install or do I need someone to install it for me?
Installation is very easy; it bolts onto the gate and post, and the provided wire is zip tied to the gate frame.
2. How much pressure can be applied without compromising the lock
Up to 1600 lbs of force; this is a significantly strong lock.
3. Is customer service available for trouble shooting?
Of course, this is our specialty. Call us any time 9am to 9pm EST at 1-800-537-4283.
|